Precision Painting Plus

Plaster Repair

Plaster is the covering given to the construction. So it’s needless to say that it should be done in a proper way.

Here are some guidelines while repairing plaster

1. Fill tiny holes

You can use a putty knife to apply spackling compound, available in small cans for touch-ups. Let dry. If the first coat shrinks as it dries and leaves a slight indentation. After that apply a second coat.

Sand lightly with fine sandpaper. Touch up with primer and paint.

2. Repair loose plaster

Remove any small, loose chunks of plaster and patch the holes. For large, loose areas, install the washers in concentric rings, starting where the plaster is firmly attached and working inward. Cover the area with joint compound.

To reinforce plaster along large cracks, install screws every 6 inches on both sides of the crack and about 1 inch away from it. Drill pilot holes with a 1/8-inch masonry drill bit. Cover the area with joint compound.

3. Mix compound

Use a setting-type joint compound such as Durabond 90 for all repairs other than tiny holes. Mix the compound in a bucket with water according to the directions. Depending on the quantity, use a potato masher, paint-mixing drill attachment or paddle mixer.

4. Fill holes and areas where plaster is missing

Fill a hole with compound to within 1/8 inch of the surface using a 6-inch spackle knife. Then scratch the wet compound in a crisscross pattern with the edge of your knife. When the scratched coat dries, apply a leveling coat.

For larger areas of missing plaster, measure a piece of drywall to fit the hole, cut the piece out with a utility knife, then screw it to the lath. Apply the compound in two stages and extend it about 2 inches onto the surrounding surface.

Apply two or three additional coats of compound, allowing complete drying between coats and feathering each coat over a wider area than the preceding one.

Use a pole sander or a similar pad sander with very fine sandpaper to smooth the compound after it has dried.

5. Repair hairline cracks

Apply a thin coat of compound on the wall along the crack. Embed paper drywall reinforcing tape in the compound immediately and smooth with a spackle knife.

Image Credit

http://i.ehow.com/images/GlobalPhoto/Articles/2070730/Image004-main_Full.jpg

Plaster Repair

Plaster is the covering given to the construction. Plasters may get damaged due to many reasons. Repairs of plasters should be done with very care. Before making any repairs to a plaster check overall condition of the area. Bulging and Sponginess means plaster has pulled away from its foundation. Damaged wall plaster will remain stable for a while. But damaged ceiling plaster is hazardous. Its better to call a professinal for repair job.

Good plaster has a look, feel, and good acoustic properties. It gives rich decorative detail. Walls expand/move/breathe due to temperature changes. Due to this slowly there develops cracks in the walls and ceilings. Plaster works are easy to repair. But assure that you do it in proper time.

Types of plaster repair are:

1. Fill Tiny Holes
2. Repair Loose Plaster
3. Fill Holes & Areas Where Plaster Is Missing
4. Repair Hairline Cracks

Image Credit
www.wilsonspainting.com/section4/image_3.jpg

One of the exciting place to design is the office. There are many various options for office interior design. Designing an office in a corporate environment, known for a review of the company’s objectives & goals. The look and feel of the office should be an regulating factor in making a client.

Some important factors should be considered while designing office interior. See visually..

Bedroom Makeover Ideas

If you want to change the look of your bedroom, one of the popular option is bedroom makeover. It can give a entire new look of your bedroom. There are many ways in which a makeover can be done in the house. It’s all depend upon your requirement & budget.

Some makeovers are very simple, cost effective and will give you a good feel also. It’s all include painting of the room with a new color or changing the position of your furniture in the room, whatever you want.

There are several ideas for doing a makeover in your bedroom.

1. Change The Paint: It’s an economical way in which you can do a makeover of your room easily. Changing the paint will automatically change the entire look of your room.

2. Some Colorful Cushions: You can add some colorful cushions all around your room. Make sure that all the furniture in the room have some of them.

3. Renovate The Wardrobe: You can renovate your old wardrobe. Either repaint the entire wardrobe or only paint the frames. Try something unique which can give your room a new look.

4. Change The Linen: Replacing the old linen will also add value of your room. The change of linen includes changing the bed covers, curtains, sofa covers etc. It can also change the entire look of your bedroom.

Try these tips. You will discover your bedroom with a new vision.

Image Credit
www.hgtv.ca

Bedroom flooring depend on the location and climate. It’s your private room. Bedroom flooring should be soothing, refreshing and nice looking. This gives aesthetic sense to create a romantic atmosphere to the bedroom. It also describes your personality and the way you want to live.

See visually – Ideas For Bedroom Flooring.

Linoleum Flooring

Linoleum flooring looks like vinyl flooring, but it’s not. It’s environment friendly flooring. It stays beautiful in rough conditions and is water resistant as well. Linoleum is made of linseed oil–along with wood flour, tree resins, cork dust, a touch of ground limestone, and and pigments for color.

It’s pressed onto a jute base. The name is a concoction of the “lin” from linseed and “oleum” from oil.

The best thing of Linoleum Flooring is durability. It’s also a little bit softer to walk on than ceramic tile. Linoleum looks drab compared to vinyl. New types of linoleum that offer more vibrant colors. You have to maintain this flooring each & every year.

Image Credit:

http://www.gharexpert.com

Concept Of Modern Bedroom

The bedroom is the place where we spend our vital time. We sleep and relax there. It is a room where we dream. Some color and decorative ideas can make your bedroom amazingly different. Interior design can transform your bedroom out stand. You should make your bedroom very simple with minimal interior design. Bedroom should neat and always cleen.

Bedroom is the most private and personalised in a house. Bedroom reflects your lifestyle, your needs and preferences. It is the place where you get back your energy. There are some facts that need to consider while designing your bedroom.

1. Bedroom Lighting
2. Bedroom Curtains & Blinds
3. Bedroom Color & Walls
4. Bedroom Furniture & Storage
5. Bedroom Floors

Modern Bedroom Design

Image Credit:

http://freshome.com

http://modernhomesdesign.com

Rough Luxe

Rough luxe is a combination of old and new furniture and art of luxurious fabrics with cheap materials and distressed walls. Rough Luxe is an artful dissonance. One of the big part of the rough luxe is bare plastering. Antique style furniture make a room look opulent, slightly neglected and elegant. Large distressed items in a room, like old shutters or a piece of furniture will give a rough luxe style to the room.

Choosing of cushions with trim, threadbare antique rugs and hanging of framed paintings will give rough luxe look. Open shelving, peeling walls, wood panelling and a fake deer’s head gives perfect rough luxe look. Above all some old & new combination of room accessories and room painting make any room a little bit rough and a lot of luxury.

Image Credit

http://www.channel4.com

Cork Flooring

One of the most beautiful, pleasant and comfortable flooring is Cork Flooring. It is light in weight and easy to install. Cork flooring is anti slippery & hassle free. Its durable enough to handle all kinds of traffic. Cork flooring is eco friendly. It is renewable & sustainable. Installing cork floors can be a little expensive. Cork is a natural product. Cork flooring can enriches any interior.

Image Credit

http://jebcustomconstruction.com

Bamboo Flooring

Bamboo flooring is one of the most desired hardwood flooring. Bamboo flooring possesses commentable qualities, when compared to other popular wood type. it needs no finish work at all and is factory prefinished with a state-of-the-art UV resistant varnish that requires absolutely no sanding, staining or filling.

Bamboo Floor Finishes

Bamboo floors are divided into carbonized boards & natural color boards depending on the treatment of the bamboo strips. Natural color floors takes on the natural luster of bamboo. While the color of the carbonized flooring is treated under high temperature and pressure, is a darker amber and more uniform. The factory finished products have UV-cured finishes. Which have low VOC emissions. Any of these products should make an attractive, durable floor.

Some of finishes..

Awesome Bamboo Flooring

Bamboo Floor

Bamboo Flooring

Image Credit
www.floorbiz.com
www.bambwood.com